This 16-hour package is intended for Louisiana water operators with one or two certifications. The following approved courses are included:
- Pumps Part 1
- Electrical Safety (NFPA 70E 2024)
- Fluid Mechanics
- Water Distribution Systems
Course Format: Text
Credit Type: Water, Wastewater
Course ID(s): 68991, 68999, 68990, 69002
Approved By: Department of Health And Hospitals - Center For Environmental Health
16-Hour Package for Water Operators
- Pumps Part 1 [42 Activities]
- 01. The Development of Pumps
- 02. Pumping Systems
- 03. Water Pumping Systems
- 04. Chemical Pumping Systems
- 05. Waste Pumping Systems
- 06. High-Viscosity Material Pumping Systems
- 07. Solid Pumping Systems
- 08. Pumping Terminology
- 09. Calculating Total Head
- 10. Horsepower Calculations
- 11. Total Energy vs Available NPSH
- 12. Available NPSH vs Required NPSH
- 13. Pump Performance Curves
- 14. Head Capacity Curves
- 15. Curve Families
- 16. Pump Selection
- 17. Centrifugal Pumps
- 18. Pump Part Definitions
- 19. End-Suction Casing Configurations
- 20. Split-Case Centrifugal Pumps
- 21. Double-Volume Pumps
- 22. Impeller Types
- 23. Wear Rings
- 24. Shafts, Bearings, and Sleeves
- 25. Turbine Pumps Overview and Lineshaft Turbines
- 26. Can Turbines
- 27. Submersible Turbines
- 28. Flow Patterns
- 29. Axial-Flow Propeller Pumps
- 30. Mixed-Flow Propeller Pumps
- 31. Special Propeller Pumps and Turbine Pump Construction
- 32. Vertical Turbine Pump Application
- 33. Regenerative Turbine Pumps
- 34. Introduction to Rotary Pumps
- 35. External-Gear Pumps
- 36. Internal-Gear Pumps
- 37. Lobe Pumps
- 38. Screw Pumps
- 39. Vane Pumps
- 40. Rotary Piston Pumps
- 41. Flexible-Members Pumps
- 42. Rotary Pump Installations
- Electrical Safety (NFPA 70E 2024)
- Electrical Safety (NFPA 70E 2024) Part 1 [25 Activities]
- 01. Article 90: Sections 90.1, 90.2, 90.3
- 02. Article 90: Sections 90.4, 90.5, 90.6
- 03. Article 100 Definitions
- 04. Article 105, Application of Safety-Related Work Practices and Procedures
- 05. Article 110, General Requirements for Electrical Safety-Related Work Practices
- 06. Section 110.3, Electrical Safety Program.
- 07. Section 110.4, Training Requirements.
- 08. Section 110.5 Host and Contract Employers?? Responsibilities.
- 09. Section 110.6, Test Instruments and Equipment.
- 10. Section 110.7(A)&(B), ?Portable Cord- and-Plug-Connected Electric Equipment.
- 11. Section 110.7(C)-(F), ?Portable Cord- and-Plug-Connected Electric Equipment.
- 12. Section 110.8, Ground-Fault Circuit-Interrupter (GFCI) Protection.
- 13. Sections 110.8, Ground-Fault Circuit-Interrupter (GFCI) Protection. 110.9 Overcurrent Protection Modification. 110.10 Equipment Use.
- 14. Article 120, Establishing an Electrically Safe Work Condition
- 15. Section 120.2, Lockout/Tagout Program.
- 16. Section 120.3, Lockout/Tagout Principles.
- 17. Section 120.4, Lockout/Tagout Equipment.
- 18. Section 120.5 Lockout/Tagout Procedures PART-I.
- 19. Section 120.5 Lockout/Tagout Procedures PART-II.
- 20. Section 120.6, Process for Establishing and Verifying an Electrically Safe Work Condition.
- 21. Article 130: Work Involving Electrical Hazards
- 22. Section 130.5, Arc Flash Risk Assessment.
- 23. Section 130.7(C)(1) through (C)(8), Personal and Other Protective Equipment.
- 24. Section 130.7(C)(9) through (C)(15), Personal and Other Protective Equipment.
- 25. Section 130.7(C). Personal Protective Equipment (Tables).
- Electrical Safety (NFPA 70E 2024) Part 2 [25 Activities]
- 01. Section 130.7(D). Other Protective Equipment.
- 02. Section 130.8(A)-(D). Other Precautions for Personnel Activities.
- 03. Section 130.8(E) (N). Other Precautions for Personnel Activities.
- 04. Section 130.8(O). Alerting Techniques.
- 05. Section 130.9, Work Within the Limited Approach Boundary or Arc Flash Boundary of Overhead Lines
- 06. CHAPTER 2, SAFETY-RELATED MAINTENANCE REQUIREMENTS.
- 07. Article 205, General (Requirements)
- 08. Article 210, Substations, Switchgear Assemblies, Switchboards, Panelboards, Motor Control Centers, and Disconnect Switches
- 09. Article 215, Premises Wiring
- 10. Article 220, Controller Equipment
- 11. Article 225, Fuses and Circuit Breakers
- 12. Article 230, Rotating Equipment
- 13. Article 235, Hazardous (Classified) Locations
- 14. Article 240: Batteries and Battery Rooms
- 15. Article 245, Portable Electric Tools and Equipment
- 16. Article 250, Personal Safety and Protective Equipment
- 17 CHAPTER 3, SAFETY REQUIREMENTS FOR SPECIAL EQUIPMENT.
- 18. Article 310, Safety-Related Work Practices for Electrolytic Cells.
- 19. Article 320, Safety Requirements Related to Batteries and Battery Rooms.
- 20. Article 330, Safety-Related Work Practices: Lasers
- 21. Article 340, Safety-Related Work Practices: Power Electronic Equipment.
- 22. Article 350, Safety-Related Work Requirements: Research and Development Laboratories
- 23. Article 360, Safety-Related Requirements for Capacitors.
- 24. Informative Annex A, Informative Publications.
- 25. Informative Annex J, Energized Electrical Work Permit.
- Electrical Safety (NFPA 70E 2024) Part 1 [25 Activities]
- Fluid Mechanics [11 Activities]
- 01. Definition of a Fluid
- 02. Fluids Distribute Forces
- 03. Definition of Pressure
- 04. Measuring Pressure
- 05. Sources of Fluid Pressure
- 06. Gauge Verses Absolute Pressure
- 07. Liquid Seeks Its Own Level
- 08. Velocity Head Verses Static Pressure
- 09. The Bernoulli Effect and Venturi Applications
- 10. Friction Head
- 11. The Siphon
- Water Distribution Systems [12 Activities]
- 01. Introduction
- 02. Topologies
- 03. Pipeline Operation
- 04. Meters, Valves, and Hydrants
- 05. Pumps and Motors
- 06. Storage Tanks & Facilities
- 07. Fire Protection
- 08. SCADA Systems
- 09. EPA Regulations and Groundwater Rule
- 10. Maintenance
- 11. Potential System Problems
- 12. Distribution System Water Quality Issues
Course Completion
- Mandatory Questionnaire
- Pumps Part 1 - Certificate of Achievement
- Electrical Safety (NFPA 70E 2024) - Certificate of Achievement
- Fluid Mechanics - Certificate of Achievement
- Water Distribution Systems - Certificate of Achievement